Wiper Switch: Service and Repair

Windshield Wiper and Washer Switch Replacement

Removal Procedure




1. Remove the tilt wheel lever (4). Refer to Tilt Lever Replacement (Tilt Lever Replacement).
2. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
3. Separate and remove the upper (1) and the lower (3) steering column covers.




4. Disconnect the electrical connector from the wiring harness.
5. Release the upper and lower retaining clips and slide the wiper/washer switch from the steering column lock module.

Installation Procedure




1. Slide the wiper/washer switch into the steering column lock module until the upper and lower retaining clips snap into place.
2. Connect the electrical connector into the wiring harness.




3. Install the upper (1) and the lower (3) steering column covers.
4. Install the tilt wheel lever (4). Refer to Tilt Lever Replacement (Tilt Lever Replacement).
5. Install the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).