Security Indicator Malfunction (w/o LED)

Security Indicator Malfunction (w/o LED)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provide an overview of each diagnostic category.

Circuit/System Description

The security indicator acts as a status indicator for the content theft deterrent (CTD) system when the ignition is OFF and as a fault indicator for the immobilizer system when the ignition is ON. When either the body control module (BCM) or theft deterrent module (DTM) requires the security indicator to be illuminated, a serial data message is sent to the instrument panel cluster (IPC), which will illuminate the indicator.

Reference Information
Schematic Reference

Theft Deterrent System Schematics (Theft Deterrent System Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Content Theft Deterrent (CTD) Description and Operation (Content Theft Deterrent (CTD) Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, verify the security indicator illuminates when performing the scan tool IPC Lamp Test.

If the security indicator does not illuminate, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for IPC replacement, setup, and programming