B1527

DTC B1527

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC B1527
- High Parasitic Load Detected

Circuit/System Description

The body control module (BCM) monitors the state of charge (SOC) of the electrical system. If the BCM senses that the SOC at key-on is 30 percent lower than what it was when the engine was running, DTC B1527 will set.

Conditions for Running the DTC

The ignition must be in Accessory or Run mode for this code to set.

Conditions for Setting the DTC

The SOC at key-on is 30 percent lower than when the engine was running and battery drain is more than 2 amps.

Action Taken When the DTC Sets

There is no battery telltale illuminated or DIC message displayed.

Conditions for Clearing the DTC

* The DTC will clear if the fault does not return after 50 consecutive ignition cycles.
* The DTC will clear when run SOC is greater than or equal to 80 percent.

Reference Information
Schematic Reference

Starting and Charging Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Charging System Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.

Circuit/System Verification

Ignition ON, compare the scan tool Prev. State of Charge and Start Up State of Charge parameters. The readings should not differ by more than 30 percent.

If the readings differ by more than 30 percent, refer to Battery Electrical Drain/Parasitic Load Test (Battery Electrical Drain/Parasitic Load Test).

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.