Spot Lamp Bulb Replacement

Spot Lamp Bulb Replacement (Impala RPO 7X6, 7X7)

Removal Procedure




1. Remove the spot lamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
2. Disconnect the electrical connector.




3. Remove the screw from the spot lamp bezel.




4. Remove the spot lamp bezel from the spot lamp.




5. Remove the lamp from the spot lamp.




6. Remove spot lamp bulb retaining clip.




7. Remove the spot lamp bulb from the spot lamp.




8. Disconnect the spot lamp bulb electrical connector.

Installation Procedure




1. Connect the spot lamp bulb electrical connector.




2. Install the spot lamp bulb to the spot lamp.




3. Install the spot lamp bulb retaining clip.





Note: The spot lamp assembly must be clocked in the UP position, refer to the emblem on the face of the lamp.

4. Holding the spot lamp in position, install the spot lamp bezel to the spot lamp.

Caution: Refer to Fastener Caution (Fastener Caution).




5. Install the spot lamp bezel screws.

Tighten the spot lamp bezel screws to 2 Nm (18 lb in).




6. Using a small flat-bladed tool, install the spot lamp wiring harness push-in retainer to the windshield garnish molding.
7. Connect the electrical connector.
8. Inspect the spot lamp for proper operation.