Drive Sprocket and Turbine Shaft Assemble

Drive Sprocket and Turbine Shaft Assemble

Special Tools
* J 29569-1 - Turbine Shaft Seal Installer (Chain Side) Expander
* J 29569-2 - Turbine Shaft Seal Installer (Chain Side) Compressor
* J 29829-1A - Turbine Shaft Seal Installer (Converter Side) Expander
* J 29829-2 - Turbine Shaft Seal Installer (Converter Side) Compressor
* J 36850 - Assembly Lubricant or equivalent

For equivalent regional tools, refer to Special Tools (Tools and Equipment).




1. Inspect the driven sprocket (506) for the following:

* Worn or chipped teeth
* Uniform teeth size
* Stripped or damaged splines
* Bearing surface damage

2. Inspect the fourth clutch shaft thrust washer (505) and the driven sprocket thrust washer (508) for wear or cracks.




3. Inspect the drive sprocket (516) for the following:

* Worn or chipped teeth
* Uniform teeth size
* Stripped or damaged splines
* Bearing surface damage

4. Inspect the turbine shaft (518) for the following:

* A cracked sleeve
* Damaged bushing journals
* Stripped or damaged splines

5. Inspect the drive sprocket thrust washers (514, 517) for wear or cracks.




6. Insert the turbine shaft (518) into the drive sprocket (516) and attach the drive sprocket retaining ring (515).




7. Install J 29569-1 - seal installer expander onto the turbine shaft (518). Coat the tool shaft with J 36850 - lubricant or equivalent.
8. Slide the turbine shaft oil seal rings (513) into position.




9. Use J 29569-2 - seal installer compressor in order to size the turbine shaft oil seal rings (513).




10. Install J 29829-1A - seal installer expander onto the turbine shaft (518). Coat the tool shaft with J 36850 - lubricant or equivalent.
11. Slide the turbine shaft oil seal ring (519) into position.




12. Use J 29829-2 - seal installer compressor in order to size the turbine shaft oil seal ring (519).