Tightening Torques & Sequences

CYLINDER HEAD




Cylinder Head Bolt
First Pass 30 Nm (22 lb ft)
Final Pass 155 degrees

CYLINDER HEAD BOLT RE-USABILITY

Notice: Do not use any sealing material. Always use new cylinder head bolts.

INTAKE MANIFOLD




Intake Manifold to Cylinder Head Bolt/Nut 10 Nm (89 lb in)

CAMSHAFT BEARING CAP

Tighten the camshaft cap bolts in increments of 3 turns until they are seated.
Camshaft Cap Bolt 10 Nm (89 lb in)

CRANKSHAFT MAIN BEARING




Crankshaft Bearings - Lower Crankcase to Block - Bedplate
First Pass 20 Nm (15 lb ft)
Final Pass 70 degrees




Crankcase Perimeter Bolts 25 Nm (18 lb ft)

CONNECTING ROD BOLT

Connecting Rod Bolt
First Pass 25 Nm (18 lb ft)
Final Pass 100 degrees

CRANKSHAFT PULLEY

Crankshaft Balancer Bolt
First Pass 100 Nm (74 lb ft)
Final Pass 125 degrees

FLYWHEEL/FLEXPLATE

Flywheel Bolt - Automatic Transmission
First Pass 53 Nm (39 lb ft)
Final Pass 25 degrees

Flywheel Bolt - Manual Transmission
First Pass 53 Nm (39 lb ft)
Final Pass 25 degrees

OIL PUMP

Oil Pump Cover Bolt 6 Nm (53 lb in)

EXHAUST MANIFOLD




Exhaust Manifold to Cylinder Head Nut - 2 passes 14 Nm (124 lb in)

WATER PUMP

Water Pump Bolts 25 Nm (18 lb ft)