Transmission Control Replacement

Transmission Control Replacement

Removal Procedure

1. Set the park brake and chock the wheels.
2. Remove the console. Refer to Front Floor Console Replacement (Service and Repair).




3. Disconnect the transmission range selector lever cable terminal (2) from the shift lever pin (3).
4. Release the transmission range selector lever cable retainer (1) and remove the transmission range selector cable from the transmission control lever base (4).




5. Remove the park lock cable end (1) from the park lock lever by sliding the cable end reward off the park lock lever pin
6. Release the park lock cable retainer (2) from the shift control base.




7. Remove the transmission shift control nuts (1).
8. Remove the transmission shift control (2).

Installation Procedure




1. Install the transmission shift control (2).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transmission shift control nuts (1) and tighten to 25 Nm (18 lb ft).




3. Attach the park lock cable to the shift control base. Ensure the park lock cable retainer (2) is fully secured to the shift control base.
4. Install the park lock cable on the park lock lever by sliding the cable end (1) over the park lock lever pin.




5. Install the transmission range selector lever cable retainer (1) to the shift lever base. (4).
6. Install the transmission range selector lever cable terminal (2) to the shift lever pin (3).
7. Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment (Adjustments).
8. Adjust the park lock cable. Refer to Park Lock Cable Adjustment (6T40/6T45 - Automatic Transmission).
9. Install the console. Refer to Front Floor Console Replacement (Service and Repair).