11. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Tools Required
* EN 46106 Flywheel Holding Tool
* J 38416-2 Crankshaft Button
* J 41816 Crankshaft Balancer Remover




1. Install the EN 46106 through the starter mounting hole.




2. Remove the crankshaft balancer bolt.




3. Install the J 38416-2 in the nose of the crankshaft.
4. Install the J 41816 in order to remove the crankshaft balancer.
5. Tighten the center bolt of the J 41816 in order to pull the crankshaft balancer off of the crankshaft.
6. Remove the J 41816 from the crankshaft balancer.




7. Remove the EN 46106.