Tightening Torques & Sequences
CYLINDER HEADRight Sequence:
Left Sequence:
Cylinder Head Bolt - M8
First Pass 15 Nm (11 lb ft)
Final Pass 75 Degrees
Cylinder Head Bolt - M11
First Pass 30 Nm (22 lb ft)
Final Pass 150 degrees
CYLINDER HEAD BOLT RE-USABILITY
Notice: DO NOT allow oil on the cylinder head bolt bosses. DO NOT reuse the old cylinder head bolts.
INTAKE MANIFOLD
Upper-to-Cylinder Head Bolt - Long 23 Nm (17 lb ft)
Upper-to-Cylinder Head Bolt - Short 23 Nm (17 lb ft)
Upper-to-Lower Intake Manifold Bolt 23 Nm (17 lb ft)
CAMSHAFT BEARING CAP
Right (SFI):
Camshaft Cap Bolt 10 Nm (89 lb in)
CRANKSHAFT MAIN BEARING BOLT
Inner
First Pass 20 Nm (15 lb ft)
Final Pass 80 degrees
Outer
First Pass 15 Nm (10 lb ft)
Final Pass 110 Degrees
Side
First Pass 30 Nm (22 lb ft)
Final Pass 60 Degrees
CONNECTING ROD BOLT
Connecting Rod Bolt
First Pass 30 Nm (22 lb ft)
Second Pass - Counterclockwise Back Off to Zero
Third Pass 25 Nm (18 lb ft)
Final Pass 110 Degrees
CRANKSHAFT PULLEY
Crankshaft Balancer Bolt
First Pass 100 Nm (74 lb ft)
Final Pass 150 Degrees
FLYWHEEL/FLEXPLATE
Engine Flywheel Bolt
First Pass 30 Nm (22 lb ft)
Final Pass 45 Degrees
OIL PUMP
Oil Pump Bolt 23 Nm (17 lb ft)
Oil Pump Cover Bolt 13 Nm (115 lb in)
EXHAUST MANIFOLD
Exhaust Manifold Bolt 20 Nm (15 lb ft)
WATER PUMP
Water Pump Bolt 10 Nm (89 lb in)