B2530

DTC B2530

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptors
DTC B2530 01
- Front Fog Lamps Control Circuit Short to Battery

DTC B2530 02
- Front Fog Lamps Control Circuit Short to Ground

DTC B2530 04
- Front Fog Lamps Control Circuit Open

Diagnostic Fault Information





Circuit/System Description

The front fog lamp relay is supplied with battery voltage at all times. The front fog lamp switch signal circuit is grounded momentarily by pressing the front fog lamp switch. The body control module (BCM) energizes the front fog lamp relay by applying ground to the front fog lamp relay control circuit. When the front fog lamp relay is energized, the relay switch contacts close and battery voltage is applied through the front fog lamp fuse to the front fog lamp supply voltage circuit which illuminates the front fog lamps.

Conditions for Running the DTC

Front fog lamps activated.

Conditions for Setting the DTC

B2530 01

The BCM detects a short to battery on the control circuit.

B2530 02

The BCM detects a short to ground on the control circuit.

B2530 04

The BCM detects an open control circuit.

Action Taken When the DTC Sets

The front fog lamps will not operate.

Conditions for Clearing the DTC

The condition for setting the DTC is not longer present.

Reference Information
Schematic Reference

Fog Lights Schematics (Fog Lights Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Exterior Lighting Systems Description and Operation (Exterior Lighting Systems)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, command the Front Fog Lamps ON and OFF with a scan tool. The front fog lamps should turn ON and OFF when changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the X2 harness connector at the X50A underhood fuse block.
2. Connect a test lamp between B+ and the control circuit terminal 19.
3. Ignition ON, command the Front Fog Lamps command ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

• If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K9 BCM.
• If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

4. If all circuits test normal, replace the X50A underhood fuse block.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Accessory Wiring Junction Block Retainer Replacement (Removal and Replacement)
* Control Module References (Programming and Relearning) for BCM replacement, setup, and programming