C0895

DTC C0895

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptors
DTC C0895 03
- Device Voltage Below Threshold - PSCM

DTC C0895 11
- Device Voltage Above Maximum Threshold - PSCM

DTC C0895 12
- Device Voltage Below Minimum Threshold - PSCM

Diagnostic Fault Information





Typical Scan Tool Data





Circuit/System Description

Voltage is supplied to the power steering control module (PSCM) by the battery positive (B+) voltage circuit. The PSCM monitors the supplied voltage to determine if it is within a valid operating range. Damage to components, and incorrect data may occur if the voltage is out of range. The PSCM disables all outputs, and sets DTC C0895 if high or low battery voltage is detected.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

Battery voltage is outside the normal range of 9.0-15.5 volts.

Action Taken When the DTC Sets

The PSCM disables all functionality.

Conditions for Clearing the DTC

* A current DTC will clear when the PSCM receives battery voltage in the normal range of 9-15.5 volts.
* A history DTC will clear if the condition does not return after 50 consecutive ignition cycles.

Diagnostic Aids

* A high or low voltage value in multiple modules indicates a concern in the charging system.
* Overcharging with a battery charger or jump starting can cause this DTC to set.

Reference Information
Schematic Reference

Power Steering Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Charging System Description and Operation (w/RVC) (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and 15.0 volts.

• If not within the specified range, refer to Charging System Test (Charging System Test).

2. Observe the scan tool PSCM Battery Voltage Signal parameter. The reading should be between 12.6 and 15.0 volts.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connectors at the PSCM.
2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground circuit terminal 2 X1 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Verify that a test lamp illuminates between the B+ circuit terminal 1 X1 and ground.

• If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the PSCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for PSCM replacement, setup and programming.