DTC 024
DTC 024
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC 024
- PPS Ignition 1 Voltage Performance
Diagnostic Fault Information
Circuit/System Description
The passenger presence system (PPS) module has an ignition 1 voltage input. The PPS continually monitors itself for faults. If the voltage on this circuit falls below a certain threshold, the PPS will set DTC 024. When the PPS detects this DTC within the PPS it will notify the customer of the enable/disable status by illuminating the OFF indicator on the PASSENGER AIR BAG ON/OFF indicators. Then the PPS will communicate to the sensing and diagnostic module (SDM) through serial data communication circuit that a PPS fault is present. The SDM will then set DTC B0081 indicating a problem within the PPS and will suppress the deployment of the instrument panel (I/P) module and then illuminate the AIR BAG warning indicator.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
The PPS detects ignition 1 voltage is less than 8 volts for 500 milliseconds.
Action Taken When the DTC Sets
* The PPS will set a DTC, and then communicate with the SDM.
* The SDM will set DTC B0081.
* The SDM disables the I/P module deployment loop.
* The PPS will illuminate the passenger air bag status OFF indicator.
* The SDM requests the instrument panel cluster (IPC) to illuminate the AIR BAG warning indicator.
Conditions for Clearing the DTC
* The condition for setting the DTC no longer exists.
* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.
Diagnostic Aids
The PPS will set DTC 024 as a history code only, when the ignition voltage has fallen below 8 volts. This is a normal condition for DTC 024 and it should be diagnosed as a current DTC.
Reference Information
Schematic Reference
SIR Schematics ([1][2]Air Bag Systems)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
SIR System Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Circuit/System Testing
Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
* PPS module
* PPS wiring harness connector
1. Ignition OFF, disconnect the harness connector at the PPS module.
2. Ignition OFF, test for less than 1.0 ohm between the ground circuit terminal 5 and ground.
• If greater than the specified range, test the low reference circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit terminal 9 and ground.
• If the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, test or replace the PPS module.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* SIR/SRS Wiring Repairs (SIR/SRS Wiring Repairs)
* Control Module References (Programming and Relearning) for PPS replacement, setup, and programming