Rear Suspension

Tie Rod Replacement (Inner)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Disconnect the outer tie rod end from the suspension knuckle. Refer to Tie Rod Replacement (Inner).
4. Remove the nut (1) retaining the rear suspension adjustment link to the crossmember.
5. Remove the rear suspension adjustment link (2) from the vehicle.

Installation Procedure




1. Install the rear suspension adjustment link (2) to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the rear suspension adjustment link nut (1) to the back side of the crossmember and tighten to 60 Nm (44 lb ft).
3. Install the outer tie rod end into the suspension knuckle. Refer to Tie Rod Replacement (Inner).
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
5. Lower the vehicle.
6. Adjust the rear wheel toe as necessary. Refer to Rear Toe Adjustment (Rear Toe Adjustment).