Steering Column Tilt Head Replacement

Steering Column Tilt Head Replacement

Special Tools

J 21854-01 - Pivot Pin Remover

For equivalent regional tools, refer to Special Tools (Tools and Equipment).

Removal Procedure

1. Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).




2. Use the J 21854-01 - remover to remove the pivot pins (1).




3. Pull the tilt arm in order to disengage the steering wheel lock shoes from the dowel pins (2) in the steering column support assembly.




4. Remove the steering column tilt head (1).

Installation Procedure




1. Position the steering column tilt head (1) on to the steering column.




2. Using the tilt lever position, lock the shoes to the dowel pins (2).
3. Rotate the steering column tilt head (1) in order to align the holes for the pivot pins.




4. Install the 2 pivot pins by performing the following steps:

1. Lubricate the pivot pins (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (Fluid Type Specifications) for the recommended lubricant.
2. Press the pivot pins (1) until the pins are firmly seated.
3. Stake the pivot pins at three new locations (1).

5. Install the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).