C0558
DTC C0558
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0558 00
- Calibration Data Not Programmed/Learned
DTC C0558 01
- Calibration Data Not Programmed/Learned short to battery
DTC C0558 02
- Calibration Data Not Programmed/Learned short to ground
DTC C0558 03
- Calibration Data Not Programmed/Learned voltage below threshold
DTC C0558 04
- Calibration Data Not Programmed/Learned open circuit
Circuit/System Description
The electronic brake control module (EBCM) must be calibrated.
Conditions for Running the DTC
* The ignition is ON.
* Ignition voltage is greater than 8 volts.
Conditions for Setting the DTC
The EBCM has not been calibrated.
Actions Taken When DTC Sets
* The EBCM disables THE traction control system (TCS) for the duration of the ignition cycle.
* The ABS remains functional.
* The Traction OFF Indicator turns ON.
* The IPC message center displays SERVICE TRACTION CONTROL.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
ABS Description and Operation (Description and Operation)
Electrical Information Reference
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Programming and Relearning (Programming and Relearning) for Scan Tool Information
Circuit/System Verification
Calibrate the EBCM. Refer to Programming and Relearning (Programming and Relearning).
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Programming and Relearning (Programming and Relearning) for EBCM calibration