Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor Replacement

Removal Procedure




1. Remove the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement Intake Manifold Cover Replacement.
2. Remove the power steering pump, if required. Refer to Power Steering Pump Replacement.
3. Disconnect the fuel injector wiring harness electrical connector from the camshaft position (CMP) sensor.




4. Remove the CMP sensor bolt.
5. Remove the CMP sensor.
6. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.

Installation Procedure




1. Replace the O-ring seal if damaged, lubricate the NEW O-ring with clean engine oil.
2. Install the CMP sensor.

Caution: Refer to Fastener Caution Fastener Caution.

3. Install the CMP sensor bolt.

Tighten the bolt to 10 Nm (89 lb in).




4. Connect the fuel injector wiring harness electrical connector to the CMP sensor.
5. Install the power steering pump, if required. Refer to Power Steering Pump Replacement.
6. Install the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement Intake Manifold Cover Replacement.