Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the oil pressure sensor heat shield bolts and shield.




3. Disconnect the engine wiring harness electrical connector (1) from the oil pressure sensor.




4. Remove the engine oil pressure sensor.

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the engine oil pressure sensor.

Tighten the sensor to 16 Nm (12 lb ft).




2. Connect the engine wiring harness electrical connector (1) to the oil pressure sensor.




3. Install the oil pressure sensor heat shield and bolts.

Tighten the bolts to 10 Nm (89 lb in).

4. Lower the vehicle.