Operation CHARM: Car repair manuals for everyone.

P0706




DTC P0706

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0706 Transmission Range Switch Circuit Malfunction (Short)

Conditions for Setting the DTC

* The transmission control module (TCM) detects more than 2 or more signals from the transmission range (TR) switch circuit for 2 s continuously.
* Detection continuously occurs 5 times.

Action Taken When the DTC Sets

* The TCM will request the illumination of Hold/Malfunction Indicator Lamp (MIL) and store the DTC when the TCM detects failures on 2 consecutive ignition cycles.
* The TCM judges with the priority D2LRNP
* No timing solenoid control for N - D
* No self-learning control
* No lockup
* No preventative reverse gear control.

Conditions for Clearing the DTC

* The TCM turns OFF the Hold/Malfunction Indicator Lamp (MIL) when no further failures are detected on the next ignition cycle.
* The scan tool can clear the DTC from the TCM history.
* The TCM clears the DTC from the TCM history memory after 40 consecutive ignition cycles without fault.
* The TCM detects single "D range" signal from the TR switch.

Diagnostic Aids

Failure caused by:

* The wiring harness or connector between the TR switch and the TCM
* The TR switch
* The TCM

Circuit/System Testing





Component Testing

Test for correct resistance between the terminals listed in the table.