Aisin AY6 - Manual Transmission

DTC P080A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC P080A
- Clutch Pedal Position (CPP) Not Learned

Circuit/System Description

The clutch pedal position (CPP) is a three wire sensor, connected to a 5 V reference circuit, a low reference circuit, and a signal circuit. The engine control module (ECM) supplies 5 V to the CPP sensor, and also provides a sensor ground path on the low reference circuit. The CPP sensor sends a voltage signal to the ECM on the signal circuit. The voltage on the signal circuit will vary from a voltage less than or equal to 5 V when the clutch pedal is released to a voltage less than or equal to 1.5 V when the clutch pedal is applied.

Conditions for Running the DTC

Clutch pedal fully applied.

Conditions for Setting the DTC

Clutch pedal position not learned.

Action Taken When the DTC Sets

P080A is a Type B DTC.

Conditions for Clearing the MIL/DTC

P080A is a Type B DTC.

Reference Information
Schematic Reference

Manual Transmission Schematics (Aisin AY6 - Manual Transmission)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Transmission System Description and Operation (Aisin AY6 - Manual Transmission)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Powertrain Diagnostic Trouble Code (DTC) Type Definitions)
Scan Tool Reference

Engine Control Module Scan Tool Information (LS3, L99) (Scan Tool Testing and Procedures)Engine Control Module Scan Tool Information (LLT) (Scan Tool Testing and Procedures)for scan tool information.

Circuit/System Verification

Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn (Clutch Pedal Position Sensor Learn).

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Clutch Pedal Position Sensor Learn (Clutch Pedal Position Sensor Learn)
* Engine Control Module Replacement (Service and Repair)
* Engine Control Module Programming and Setup (LS3, L99) (Testing and Inspection)Engine Control Module Programming and Setup (LLT) (Testing and Inspection)