C0558

DTC C0558

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0558
- Calibration Data Not Programmed

Circuit/System Description

The electronic suspension control module(ESCM) performs checks of internal calibration data. If a fault condition is detected, the ESCM will set the fault DTC, and may, depending upon the fault type, have a SERVICE RIDE CONTROL or SERVICE SUSPENSION SYSTEM message displayed on the driver Information center (DIC). Recovery from any controller fault condition is attempted only after the ignition is cycled ON and OFF.

Conditions for Running the DTC

* Battery voltage is between 9-16 volts
* Ignition is ON.

Conditions for Setting the DTC

* The DTC is set when any calibration faults internal to the ESCM are detected.
* The fault is detected during 3 consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with the scan tool.

Action Taken When the DTC Sets

* The ESCM disables all system functionality.
* The ESCM sends a message to the instrument panel cluster (IPC) to display a SERVICE RIDE CONTROL or SERVICE SUSPENSION SYSTEM message.

Conditions for Clearing the DTC

* A current DTC will clear when the ESCM no longer senses the malfunction and the ignition is cycled ON and OFF.
* The DTC will remain in history until 50 ignition cycles have occurred.

Reference Information
Schematic Reference

Electronic Suspension Control Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Electronic Suspension Control Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Verify that DTC C0558 is not set.

If the DTC resets replace the ESCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for electronic suspension control module replacement, programming and setup.