Instrument Cluster Gauges Inoperative

Instrument Cluster Gauges Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

Circuit/System Description

This diagnostic procedure applies to serial data gauges located in the instrument panel cluster (IPC) which include the engine coolant temperature gauge and the volt gauge.

Reference Information
Schematic Reference

Instrument Cluster Schematics (Instrument Cluster Schematics)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Instrument Cluster Description and Operation (Instrument Cluster)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.

Circuit/System Verification

Ignition ON, with the scan tool, perform the IPC Gauge Sweep Test in the IPC Output Controls. Verify that all gauge dials move from minimum to the gauge maximum value and back to the gauge minimum value.

If all the gauges do not perform the IPC Gauge Sweep Test, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for the IPC replacement, setup and programming