Cabin Temperature Sensor / Switch: Service and Repair

Inside Air Temperature Sensor Replacement

Removal Procedure

1. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
2. Remove the driver information center (DIC) retaining screw.
3. Disconnect DIC from the instrument panel (I/P).
4. Disconnect the inside air temperature sensor from the DIC bezel.




5. Disconnect the inside air temperature sensor electrical connector.

Installation Procedure

1. Connect the inside air temperature sensor electrical connector.

Note: Ensure that the inside temperature sensor is fully seated into the DIC bezel.




2. Install the inside air temperature sensor.
3. Connect DIC to the I/P.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the DIC retaining screw.

Tighten the screw to 1.9 Nm (17 lb in).

5. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).