B1015

DTC B1015

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC B1015 00
- Vehicle Identification Number Information Malfunction

Circuit/System Description

When the ignition is turned ON, the parking assist control module receives the vehicle identification number (VIN) from the body control module. The parking assist control module will compare the VIN received to the VIN stored in memory.

Conditions for Running the DTC

Ignition voltage is between 9-16 V.

Conditions for Setting the DTC

The VIN stored in the parking assist control module does not match the received VIN.

Action Taken When the DTC Sets

* The parking assist is disabled.
* The driver information center displays SERVICE PARK ASSIST.

Conditions for Clearing the DTC

The VIN stored in the parking assist control module matches the VIN stored in the body control module.

Reference Information
Schematic Reference

Object Detection Schematics ([1][2]Collision Avoidance and Parking Assist Systems)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Object Detection Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, program the K41 Parking Assist Control Module and verify the DTC does not reset.

If the DTC is reset, replace the K41 Parking Assist Control Module

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for parking assist control module replacement, setup and programming