22. Cylinder Head Installation

Cylinder Head Installation

Special Tools

EN-45059 - Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools (Special Tools).

1. Clean the sealing surfaces.
2. Inspect for plane surface.

* Cylinder block, cylinder head
* Straight-edge, feeler gauge

3. Install the cylinder head gasket.
4. Install the cylinder head.





Caution: Refer to Fastener Caution (Fastener Caution).

Note: Note the correct tightening sequence.

5. Install NEW cylinder head bolts.
6. Tighten the bolts (1) in 5 passes. Use the EN-45059 - sensor kit.

* First pass to 25 Nm (18 lb ft).
* Second pass to 90°.
* Third pass to 90°.
* Fourth pass to 90°.
* Fifth pass to 45°.