Reading Lamps Malfunction

Reading Lamps Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) supplies the dome/reading lamps, sunshade and Instrument Panel compartment lamp with battery voltage. When switching on the following components the concerning lamps will illuminate:

* Dome/reading lamps - row
* Sunshade - left front
* Sunshade - right front
* Instrument panel compartment lamp

Reference Information
Schematic Reference

Interior Lights Schematics (Interior Lights Schematics)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Interior Lighting Systems Description and Operation (Interior Lighting Systems)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, switch the dome/reading lamps or dome/reading lamps - row ON and OFF while observing the lamp. The concerning reading lamp should illuminate when switched ON.

Circuit/System Testing

Reading Lamps Circuit Malfunction
1. Ignition OFF, disconnect the harness connector at the E37B Dome/Reading Lamps - 2nd Row.
2. Test for less than 5 ohm between the ground circuit terminal 6 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, test for greater than 11 V between the circuit terminal 1 and the ground circuit terminal B.

• If less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.

4. If all circuits test normal, test or replace the E37B Dome/Reading Lamps - 2nd Row.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Reading Lamp Bulb Replacement (Service and Repair)
* Dome Lamp Replacement (with Sunroof) (Dome Lamp Replacement (with Sunroof))Dome Lamp Replacement (without Sunroof) (Dome Lamp Replacement (without Sunroof))
* Control Module References (Programming and Relearning) for BCM replacement, setup, and programming