71. Camshaft Bearing Installation

Camshaft Bearing Installation

Special Tools

J-33049 - Camshaft Bearing Service Set

For equivalent regional tools, refer to Special Tools (Special Tools)




1. Assemble the J-33049 - Camshaft Bearing Service Set according to the manufacturer's instructions.





Caution: Severe engine damage may result if the oil holes are not correctly aligned.

2. Install the camshaft bearings in the following order:

1. Index the camshaft bearing oil holes with the engine block oil passages.
2. Place the bearing on the J-33049 - Service Set.
3. Install the third camshaft bearing.
4. Install the second camshaft bearing.
5. Install the outer camshaft bearings.




3. Apply sealer to the camshaft rear bearing hole plug. Refer to Adhesives, Fluids, Lubricants, and Sealers (Adhesives, Fluids, Lubricants, and Sealers) for recommended sealant.
4. Install the camshaft rear bearing hole plug.