C0292

DTC C0292

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0292 00
- VSES Combination Sensor Circuits

Diagnostic Fault Information





Circuit/System Description

The electronic brake control module (EBCM) supplies a reference voltage of 12 V to the yaw rate sensor/lateral acceleration sensor and the steering angle sensor. The sensor supply voltage is monitored via an internal feedback circuit to the EBCM microprocessor.

Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 V.

Conditions for Setting the DTC

The EBCM detects that the sensor supply voltage feedback indicates that the voltage level is less than 8.0 V or greater than 16.0 V for more than 30 msec, a fault is set.

Action Taken When the DTC Sets

* The EBCM turns OFF the 12 V reference circuit, until the ignition is cycled.
* The EBCM disables the traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* The driver information center (DIC) displays the Service Stabilitrak message.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

If the yaw and lateral accelerometer sensor is disconnected, DTCs will set and the EBCM will not provide 12 V reference.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the yaw rate and lateral acceleration sensor connector.
2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal 6 and ground.

• If greater than 1 ohm, test the low reference circuit terminal 6 and the EBCM ground circuit terminal 25 (JL4) terminal 45 (without JL4) for an open/high resistance. If the circuits test normal, replace the EBCM.

3. Test the lateral accelerometer 12 V reference circuit terminal 1, for an open/high resistance or a short to voltage or ground.

• If all circuits test normal, replace the yaw rate sensor/lateral acceleration sensor, and clear the yaw rate sensor offset value in the EBCM.
• If the DTC sets again after replacing the yaw rate sensor/lateral acceleration sensor, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming