C0563

DTC C0563

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC C0563 00
- Calibration Read Only Memory (ROM) Checksum Error

Circuit/System Description

The electronic brake control module (EBCM) correlates the module calibration programmed.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

Incorrect calibration programmed.

Action Taken When the DTC Sets

* The EBCM disables the antilock brakes.
* The EBCM sends a serial data message to illuminate the appropriate warning indicator/message.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

If the DTC was set after EBCM replacement, verify that the replacement EBCM and software are correct for the vehicle.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Verification

Verify that DTC C0563 is not set.

If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning)for EBCM replacement, setup, and programming