Operation CHARM: Car repair manuals for everyone.

Electronic Suspension Control




DTC C0800

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC C0800 03
- Control Module Power Circuit Low Voltage

DTC C0800 07
- Control Module Power Circuit High Voltage

Circuit/System Description

The suspension control module monitors continuous the battery voltage.

Conditions for Running the DTC

System voltage is not between 9-16 V.

Conditions for Setting the DTC

C0800 03

The suspension control module detects that the supply voltage is less then 9 V.

C0800 07

The suspension control module detects that the supply voltage is greater then 16.3 V.

Action Taken When the DTC Sets

* The electronic suspension control is disabled for the duration of the ignition cycle.

* The driver information center displays the SERVICE SUSPENSION SYSTEM message.

Conditions for Clearing the DTC

* A present DTC will clear on the next consecutive malfunction-free ignition cycle.

Reference Information

Schematic Reference

Electronic Suspension Control Schematics Electrical Diagrams

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly - Primary

Description and Operation

Electronic Suspension Control Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connectors at the K19 Suspension Control Module.

2. Ignition ON, test for 9,5-16 V between the 12 V reference circuit terminal 32 and ground.

If less than the specified range, test for a short to ground or open high resistance. If the circuits test normal replace the K19 Suspension Control Module.

If greater than the specified range, test for a short to voltage. If the circuits test normal, replace the K19 Suspension Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

* Electronic Suspension Front Position Sensor Replacement Electronic Suspension Front Position Sensor Replacement

* Electronic Suspension Rear Position Sensor Replacement Electronic Suspension Rear Position Sensor Replacement

* Control Module References Control Module References for suspension control module replacement, programming and setup.