Folding Top Number 2 Bow Bracket Replacement

Folding Top Number 2 Bow Bracket Replacement

Removal Procedure

Caution:
Always verify that no objects are in the storage area before lowering the convertible top. Lowering the convertible top when there are objects in the storage area could damage it or break the glass rear window.

1. Place all windows in the full down position.

2. Place the folding top assembly in a halfway open position.

3. Remove the number 1 bow. Refer to Folding Top Number 1 Bow Replacement Folding Top Number 1 Bow Replacement

4. Detach the headliner as necessary. Only do those steps in the headliner replacement procedure that will gain access to the part. Refer to Headlining Trim Panel Replacement (Coupe) Headlining Trim Panel Replacement (Coupe).




5. Remove the rivets (1) from the side straps (2) being serviced.





Warning

Use the proper eye protection when drilling to prevent metal chips from causing physical injury.

Note: The replacement rivets MUST be steel/stainless steel to prevent corrosion. Always check scale, to size the drill. Do Not over size hole. The rivet hole does not go through the number 3 bow. If the rivet hole is drilled through apply a layer of cloth tape over the hole before reinstalling the top cover.

6. Protect the inside of the vehicle from metal shavings while drilling.

7. Drill (1) out the two rivets (2) from the end of the bow bracket being serviced.

8. Separate the number 2 bow from the number 2 bow bracket after drilling.





Note: The folding top assembly Must be in a halfway open position.

9. Remove the clip (1) from the pin (2), the pin is welded to the counterbalance link. Reposition the counterbalance link this will allow the removal of the bow bracket from the side rail link.




10. Lift the number 2 bow bracket (2) out of the top side rail link, take note of the number 2 bow bushing (1) and washer for reinstalling.

11. Remove the number 2 bow bracket (2) from the number 2 bow (3).

Installation Procedure

1. Install the number 2 bow bracket bushing (1) and washer to the bow number (2) bracket, refer to step 8 in the removal procedure.





Note: The folding top assembly must be in a halfway open position, this will allow access to the number 2 bow bracket.

2. Install the number 2 bow bracket (2) to the side rail link.




3. Install the clip (1) to the pin (2) which is welded to the counterbalance link, repositioning the counterbalance link will allow it's reinstalling.





Note: The replacement rivets MUST be steel/stainless steel to prevent corrosion. Always check scale, to size the drill. Do Not over size hole. The rivet hole does not go through the number 3 bow. If the rivets hole is drilled through apply a layer of cloth tape over the hole before installing the top cover.

4. Use a suitable tool install the two rivets (1) to the number 2 bow and bracket, to this dimension 4.79 mm (3/16 in) 10.9 mm (0.42 in).

5. Install the number 1 bow. Refer to Folding Top Number 1 Bow Replacement Folding Top Number 1 Bow Replacement.

6. Reattach the headliner side straps as marked in the prior removal in this procedure. Headlining Trim Panel Replacement (Coupe) Headlining Trim Panel Replacement (Coupe)

7. Inspect the front edge of the folding top to windshield frame for a good seal.

8. Place the folding top in the lock position.

9. Water test the vehicle to ensure a proper water tight seal.