Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)

Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)

Perform the Initialization/Teach Process any time the sunroof motor/actuator is removed from the sunroof.

1. Ensure that the electrical harness on the headliner is connected to the sunroof motor.

2. Re-initialization (Normalization), press "Manual Close Switch" until the sunroof reaches the Close Position or stops moving.

3. Release the switch.

4. Press "Manual Close Switch" for more then 10 seconds or until the sunroof window starts and reaches the hard stop.

5. Verify the operation of the sunroof.

Note:
The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:

* The sunroof switch is not held in the close position.

* The ignition and/or battery power has been removed.

* The glass panel has not reached the closed position.

The Initialization/Teach Process must be restarted if the procedure is not carried out completely.