126. Engine Flywheel Installation

Engine Flywheel Installation

Special Tools

* EN 45059 - Angle Meter

* EN 46106 - Engine Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools Special Tools.

1. Place the engine flywheel in position on the crankshaft.

Caution:
This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.




3. Install the EN 46106 - tool.





Caution: Refer to Fastener Caution Fastener Caution.

4. Install the remaining NEW engine flywheel bolts.

1. Tighten the NEW engine flywheel bolts to 30 Nm (22 lb ft).

2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the EN 45059 - meter.




5. Remove the EN 46106 - tool.