7. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools

* EN 46106 - Flywheel Holding Tool

* J 38416-B - Harmonic Balancer Remover

* J 38416-2 - Crankshaft Button

For equivalent regional tools, refer to Special Tools Special Tools.





1. Install the EN 46106 - tool through the starter mounting hole.





2. Remove and discard the crankshaft balancer bolt (1).





3. Install the J 38416-2 - button (2) in the nose of the crankshaft.

4. Install the J 38416-B - remover (1) in order to remove the crankshaft balancer.





5. Pull the crankshaft balancer (1) off by tightening the center bolt on the J 38416-B - remover until the crankshaft balancer pulls off of the crankshaft end.

6. Remove the J 38416-B - remover and J 38416-2 - button from the crankshaft balancer.





7. Remove the EN 46106 - tool from the starter mounting hole.