Shift Control Assembly Replacement

Shift Control Assembly Replacement

Removal Procedure

1. Remove the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (With UMQ) Front Floor Console Front Cover Replacement (With UMQ)Front Floor Console Front Cover Replacement (Without UMQ) Front Floor Console Front Cover Replacement (Without UMQ)

2. Remove the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement Transmission Control Lever Knob Replacement

3. Remove the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (L99,LS3,LFX) Exhaust Muffler with Resonator, Exhaust, and Tail Pipe ReplacementExhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (LSA) Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement

4. Disconnect the propeller shaft from the transmission and position out of the way. Refer to Two-Piece Propeller Shaft Replacement (195/218mm Axle) Two-Piece Propeller Shaft Replacement (195/218mm Axle)Two-Piece Propeller Shaft Replacement (250mm Axle) Two-Piece Propeller Shaft Replacement (250mm Axle)

5. Support the transmission with a suitable jack.

6. Remove the transmission support.

7. Lower the rear of the transmission in order to gain access to the top of the transmission.





8. Using a flat-blade tool, release the left and right side shift control rod pin retainers (1,3).

9. Using a flat-blade tool, release the center shift control rod pin retainer (2).





10. Remove the left and right side shift control rod pins (1, 3).

11. Remove the center shift control rod pin (2).

12. Remove the shift control mounting nuts.

13. Remove the manual transmission control assembly from the vehicle.

Installation Procedure

1. Position the manual transmission control assembly into the vehicle.





2. Install the center shift control rod pin (2).

3. Install the left and right side shift control rod pins (1,3).





4. Install the center shift control rod pin retainer (2).

5. Rotate the left and right side shift control rod pins (1,2) in order to lock the retainers into place on the transmission.

6. Install the shift control mounting nuts.

7. Raise the transmission.

8. Install the transmission support. Refer to Transmission Mount Replacement Aisin AY6 - Manual Transmission

9. Remove the jack supporting the transmission.

10. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (195/218mm Axle) Two-Piece Propeller Shaft Replacement (195/218mm Axle)Two-Piece Propeller Shaft Replacement (250mm Axle) Two-Piece Propeller Shaft Replacement (250mm Axle)

11. Install the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (L99,LS3,LFX) Exhaust Muffler with Resonator, Exhaust, and Tail Pipe ReplacementExhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (LSA) Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement

12. Lower the vehicle.

13. Install the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (With UMQ) Front Floor Console Front Cover Replacement (With UMQ)Front Floor Console Front Cover Replacement (Without UMQ) Front Floor Console Front Cover Replacement (Without UMQ)

14. Install the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement Transmission Control Lever Knob Replacement