71. Oil Tank Assemble

Oil Tank Assemble





Caution:
Refer to Engine Oil Tank Debris Caution Engine Oil Tank Debris Caution.

Caution:
Refer to Fastener Caution Fastener Caution.

1. Install the oil transfer tube fittings (2 and 4) to the large and small oil tanks and tighten to 35 Nm (26 lb ft).

2. Assemble the transfer tube (3), large tank (5) and small tank (1).





3. Install the clamp (1).





4. Tighten the nut (1). With the nut of the clamp positioned so that the face of the nut is flush with the end of the bolt, rotate the nut clockwise 21 complete turns to apply tension to the clamp.





5. Install the screen (1) into the tank (2). Inspect for proper installation of the screen to the tank. When installed properly, the tabs on the screen will lock into the port opening at the bottom of the tank.





6. Install the O-ring (1) to the tube.

7. Install the tube (2) to the large tank (3).





8. Install the O-ring seal (4).

9. Assemble the upper (3) and lower (5) portions of the large tank. Aligning the markings made prior to disassembly.





10. Inspect for proper installation of the tube to top tank. The top of the tube (2) should locate into the opening (1) in the top portion of the tank.





11. Install the bolts (1) and bolt/studs (2) to the tank and tighten to 25 Nm (18 lb ft). Note the locations of the bolt/studs during reassembly.





12. Install the oil level indicator (1) and oil fill cap (2).