73. Exhaust Manifold Cleaning and Inspection

Exhaust Manifold Cleaning and Inspection (6.2L LS3)





Note:
Do not use the exhaust manifold-to-cylinder head gaskets again. Upon installation of the exhaust manifold, install a NEW gasket. An improperly installed gasket or leaking exhaust system may effect on-board diagnostics (OBD) II system performance.

1. Clean the exhaust manifold (600) and heat shield (603) in solvent.

Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


2. Dry the exhaust manifold with compressed air.

3. Inspect the exhaust manifold-to-cylinder head gasket surface for excessive scratches or gouging.

4. Inspect for a loose, damaged, or cracked heat shield (603).

5. Inspect the exhaust pipe studs (605) for damaged threads.





6. Use a straight edge and a feeler gauge and measure the exhaust manifold cylinder head deck for warpage.

An exhaust manifold deck with warpage in excess of 0.25 mm (0.01 in) within the 2 front or 2 rear runners or 0.5 mm (0.02 in) overall, may cause an exhaust leak and may effect OBD II system performance. Exhaust manifolds not within specifications must be replaced.