B125B
DTC B125A or B125B
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B125A
- Antenna 1 Circuit Left
DTC B125B
- Antenna 2 Circuit Right
Diagnostic Fault Information
Circuit/System Description
The digital radio receiver (DRR) receives XM satellite radio signals via 2 digital radio antennas located in each of the outside rearview mirrors. The antenna circuits are coaxial cables that carry the digital radio signal information received by the antennas to the DRR. The antenna coax also provides a path for voltage to power the antennas. Separate left and right audio signals (+) are sent from the DRR to the radio. The radio processes these signals and passes them to the audio amplifier.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage must be between 9-16V.
Conditions for Setting the DTC
B125A
The DTC will set when the DRR detects a short to voltage, short to ground, or an open/high resistance in the antenna 1 circuit.
B125B
The DTC will set when the DRR detects a short to voltage, short to ground, or an open/high resistance in the antenna 2 circuit.
Action Taken When the DTC Sets
* Digital radio reception may be poor or not available.
* The radio displays "No XM Signal" or "Check Antenna".
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Radio/Navigation System Schematics Radio/Navigation System Schematics
Connector End View Reference
Component Connector End Views Folding Top 5 Bow Lowered Switch (CM7)
Description and Operation
Radio/Audio System Description and Operation Radio/Audio System
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Special Tools
EL-48028 - Digital Radio Test Antenna
Circuit System Verification
With the vehicle outside in an area with an unobstructed view of the southern sky, tune to XM. Verify XM reception is clear and the No XM Signal message is not displayed on the radio.
Circuit/System Testing
1. Ignition OFF, disconnect the appropriate digital radio antenna coax from the digital radio receiver (DRR). Connect the EL-48028 - Digital Radio Test Antenna to the DRR.
2. Ignition ON, radio tuned to XM, verify DTC B125A/B is not current.
• If the DTC is current, replace the DRR.
3. Ignition OFF, reconnect the antenna coax to the DRR, disconnect the digital radio antenna coax from the appropriate digital radio antenna.
4. Ignition ON, test for 4.5-5.5V between the antenna coax center terminal and the coax outer shield.
• If not within the specified range, replace the antenna coax.
5. If all circuits test normal, replace the appropriate digital radio antenna.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
* Digital Radio Antenna Cable Replacement (Convertible) Digital Radio Antenna Cable Replacement (Convertible)Digital Radio Antenna Cable Replacement (Coupe) Digital Radio Antenna Cable Replacement (Coupe)
* Digital Radio Antenna Replacement Digital Radio Antenna Replacement
* Control Module References Control Module References for DRR replacement, setup, and programming