Steering Column Lock Control Module Replacement

Steering Column Lock Control Module Replacement

Removal Procedure

Warning: Refer to SIR Warning SIR Warning.


1. Disable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

Caution:
Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

2. Remove the I/P Assembly. Refer to Instrument Panel Assembly Replacement Instrument Panel Assembly Replacement.




3. Disconnect the electrical connectors at the lock module (1).




4. Remove the lock module (1) by pulling the module up to release the retaining clips and sliding the module upward from the tie bar.

Installation Procedure




1. Install the control module (1) to the retaining bracket on the tie bar.




2. Connect the electrical connector to the lock module (1).

3. Install the I/P Assembly. Refer to Instrument Panel Assembly Replacement Instrument Panel Assembly Replacement.

4. Enable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

5. Program the lock control module. Refer to Control Module References Control Module References.