B2516
DTC B2516
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC B2516 00
- Driver Exterior Lock Switch Circuit Malfunction
Diagnostic Fault Information
Circuit/System Description
The driver exterior lock switch signal circuit provides input to the keyless entry control module when the left front exterior door handle switch is activated. This input allows the keyless entry control module to detect a door lock request upon exit of the vehicle. The keyless entry control module provides voltage to the driver door lock switch via the driver door lock switch signal circuit. When the driver door lock is activated, the switch closes and the voltage signals from the keyless entry control module are pulled to ground.
Conditions for Running the DTC
Battery voltage is between 9-16 V.
Conditions for Setting the DTC
The keyless entry control module detects a short to ground.
Action Taken When the DTC Sets
The keyless entry control module ignores inputs from the exterior driver door handle switch.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Door Lock/Indicator Schematics Door Lock/Indicator Schematics
Connector End View Reference
Component Connector End Views Sunshade - Left (D6I)
Description and Operation
Power Door Latch Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool keyless entry control module Exterior Driver Door Handle Proximity Sensor parameter while using the driver door handle. The parameter should change between Active and Inactive.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the T10M Keyless Entry Antenna - Driver Door Handle.
2. Ignition ON, verify the scan tool Exterior Driver Door Handle Proximity Sensor parameter is Inactive.
• If not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal, replace the K84 Keyless Entry Control Module.
3. Connect the a 3 A jumper harness between the signal circuit terminal 3 and ground. Verify the scan tool Exterior Driver Door Handle Proximity Sensor parameter is Active.
• If not the specified value, test the signal circuit terminal 3 for an open/high resistance. If the circuit tests normal, replace the K84 Keyless Entry Control Module.
4. If all circuits test normal, test or replace the T10M Keyless Entry Antenna - Driver Door Handle.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
* Front Side Door Outside Handle Replacement Front Side Door Outside Handle Replacement
* Control Module References Control Module References for keyless entry control module replacement, setup, and programming