Cylinder Head Assembly

Cylinder Head






First pass to 25 Nm (18 lb ft)
Second pass to 90°
Third pass to 90°
Fourth pass to 90°
Fifth pass to 45°

Surface Flatness - Block Deck - Longitude
If the deck surface is out of specification, replace the cylinder head. Do not machine the cylinder head.

Surface Flatness - Block Deck - Overall
If the deck surface is out of specification, replace the cylinder head. Do not machine the cylinder head.

Surface Flatness - Block Deck - Transverse
If the deck surface is out of specification, replace the cylinder head. Do not machine the cylinder head.

Camshaft Bearing Cap Bolt

Install the 8 intake camshaft bearing cover bolts and tighten in a spiral from the inside
to the outside to 8 Nm (71 lb in)






Install the 8 exhaust camshaft bearing cover bolts and tighten in a spiral from the inside
to the outside to 8 Nm (71 lb in).






Intake Manifold Service and Repair

Exhaust Manifold Service and Repair



Camshaft Gear/Sprocket

Camshaft Position adjuster closure bolt 30Nm

Refer to Camshaft Position Actuator Adjuster Replacement. Camshaft Position Actuator Adjuster Replacement