Steering Gear Boot Replacement

Steering Gear Boot Replacement

Special Tools

CH-22610 - Keystone Clamp Pliers

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement Steering Linkage Outer Tie Rod Replacement.
3. Remove the steering linkage inner tie rod nut.




4. Remove the outer boot clamp (1).
Discard the clamp.
5. Cut the inner boot clamp (3).
Discard the clamp.
6. Remove the steering gear boot (2).
7. Clean the steering linkage inner tie rod and the steering gear boot contact area of any lubricant or debris.

Installation Procedure





Note: The steering linkage inner tie rod and the steering gear boot must be free of moisture and debris.

1. Apply lubricant to both ends of the steering gear boot (2).

Note: Ensure the larger end of the steering gear boot is firmly seated in the correct location on the steering gear.

2. Install the steering gear boot with the NEW inner boot clamp (3) loosely attached.




3. Use the CH-22610 - pliers in order to install the NEW inner boot clamp (1).





Note: Ensure the small end of the steering gear boot is firmly seated in the correct location on the steering linkage inner tie rod.

4. Install the NEW outer boot clamp (2).
5. Install the steering linkage inner tie rod nut (1).
6. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement Steering Linkage Outer Tie Rod Replacement.
7. Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.
8. Lower the vehicle.