B2910
DTC B2910
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC B2910 00
-
Steering Column Lock Password Incorrect
Circuit/System Description
The vehicle theft deterrent subsystem provides the capability to lock or unlock the steering electrically. The steering column lock control module is allowed to unlock when power mode transitions to a non off power mode and an authenticated driver identification device is present. Once the column is unlocked, a crank request can be allowed.
Conditions for Running the DTC
* The ignition is in OFF, ACCESSORY or RUN position.
* The system voltage is between 9-16 V.
Conditions for Setting the DTC
The steering column lock control module has not received the correct password or did not receive a password with the command to unlock the steering column.
Action Taken When the DTC Sets
* DTC B2910 is stored in memory.
* The driver information center displays the service column lock system warning message.
* The steering column lock indicator is ON.
* The engine will not crank.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The steering column lock control module has received the correct password with the command to unlock the steering column.
Diagnostic Aids
This DTC may set if the BCM was replaced and the steering column lock control module was not reprogrammed.
Reference Information
Schematic Reference
Column Lock Schematics [1][2]Electrical Diagrams
Connector End View Reference
Component Connector End Views Sunshade - Left (DH6)
Description and Operation
Steering Wheel and Column Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Verification
Clear all DTCs and operate the steering column lock control module within the conditions for running the DTC. The DTC should not set.
If the DTC sets, reprogram the K60 steering column lock module. If the DTC resets, replace the K60 steering column lock module.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the repair.
Control Module References Control Module References for steering column lock control module replacement, programming and setup