51. Cylinder Head Installation (LAP, LAT, LE5, LE8, LE9)

Cylinder Head Installation (LAP, LAT, LE5, LE8, LE9)

Special Tools

EN 45059 - Angle Meter

For equivalent regional tools, refer to Special Tools Special Tools.





Note:
Do not use any sealing material.

1. Install the cylinder head gasket (2) to the block.

2. Install the cylinder head (1).





Caution:
Refer to Fastener Caution Fastener Caution.

Note:
Always use new cylinder head bolts.

3. Install and tighten the cylinder head bolts in sequence.

* Tighten the bolts to 30 Nm (22 lb ft).

* Using the EN 45059 - meter, tighten the bolts an additional 155 degrees in sequence.





4. Install the front cylinder head bolts (1) and tighten to 35 Nm (26 lb ft).