B1015

DTC B1015

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1015 00

-
Vehicle Identification Number Information Malfunction

Circuit/System Description

When the ignition is turned ON, the parking assist control module and the vehicle direction camera control module receive the vehicle identification number (VIN) from the body control module. The control modules will compare the VIN received to the VIN stored in memory.

Conditions for Running the DTC

Ignition voltage is between 9-16 V.

Conditions for Setting the DTC

The stored VIN does not match the received VIN.

Action Taken When the DTC Sets

* The parking assist system or the lane departure warning system is disabled.

* The driver information center displays SERVICE PARK ASSIST or SERVICE LANE DEPARTURE SYSTEM.

Conditions for Clearing the DTC

The stored VIN matches the VIN stored in the body control module.

Reference Information

Schematic Reference

Object Detection Schematics [1][2]Collision Avoidance and Parking Assist Systems

Connector End View Reference

Component Connector End Views Sunshade - Left (DH6)

Description and Operation

Object Detection Description and Operation (UD7) Object Detection (UD7)Object Detection Description and Operation (Accessory Dealer Installed) Object Detection Description and Operation (Accessory Dealer Installed)Object Detection Description and Operation (UVC) Object Detection (UVC)Object Detection Description and Operation (UFT) Object Detection (UFT)Object Detection Description and Operation (Front View Camera with UFL) Object Detection Description and Operation (Front View Camera with UFL)

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Testing

1. Ignition ON, program the control module the DTC originally set in.

2. With a scan tool, clear the DTCs.

3. Ignition OFF.

4. Wait 60 s, then ignition ON and verify the DTC is not reset.

• If the DTC is reset, replace the control module the DTC set in.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for the parking assist control module, vehicle direction camera control module replacement, setup and programming