B2516
DTC B2516
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC B2516 00
-
Driver Exterior Lock Switch Circuit
Diagnostic Fault Information
Circuit/System Description
The exterior driver door handle contains a small sensor which allows the driver to lock the vehicle doors from the outside without using the remote keyless transmitter. The keyless entry control module supplies a 12V signal to the driver door handle switch signal circuit, when the sensor is touched, the circuit is grounded and the voltage in the signal circuit will drop. The keyless entry control module will detect the viltage drop and will then send a serial data message to the BCM to command all the doors to lock.
Conditions for Running the DTC
Transitional state from off to run.
Conditions for Setting the DTC
The keyless entry control module detects the remote control door lock/unlock signal circuit is shorted to ground for greater than 45 seconds.
Action Taken When the DTC Sets
The keyless entry control module ignores input from the left front exterior door handle sensor.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 40 ignition cycles.
Reference Information
Schematic Reference
Remote Function Schematics [1][2]Electrical Diagrams
Connector End View Reference
Component Connector End Views Sunshade - Left (DH6)
Description and Operation
Keyless Entry System Description and Operation (With ATS) Keyless Entry System Description and Operation (With ATS)Keyless Entry System Description and Operation (Without ATS) Keyless Entry System Description and Operation (Without ATS)
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Verification
Observe the scan tool Exterior Driver Door Handle Touch Sensor parameter while pressing and releasing the door handle touch sensor-driver exterior. The value should change between Active and Inactive as the sensor is pressed and released.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the T10M keyless entry antenna-driver door handle.
2. Test for less than 5 ohms between the ground circuit terminal 4 and ground.
• If greater than the specified range, test the gorund circuit for an open/high resistance.
3. Ignition ON, verify the scan tool Exterior Driver Door Handle Touch Sensor parameter is Inactive.
• If not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal, replace the K84 Keyless Entry Control Module.
4. Connect a 3A fused jumper wire between the signal circuit terminal 3 and ground, verify the scan tool Exterior Driver Door Handle Touch Sensor is Active.
• If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K84 keyless entry control module
5. If all circuits test normal, test or replace the T10M keyless entry antenna-driver door handle.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
* Front Side Door Outside Handle Replacement Front Side Door Outside Handle Replacement
* Control Module References Control Module References for the keyless entry control module replacement, setup and programming