11. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools

* EN 38416-2 - Crankshaft Button

* EN 41816 - Crankshaft Balancer Remover

* EN 46106 - Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools Special Tools.





1. Install the EN 46106 - tool through the starter mounting hole.





2. Remove and discard the crankshaft balancer bolt.





3. Install the EN 38416-2 - button in the nose of the crankshaft.

4. Install the EN 41816 - remover in order to remove the crankshaft balancer.

5. Tighten the center bolt of the EN 41816 - remover in order to pull the crankshaft balancer off of the crankshaft.

6. Remove the EN 41816 - remover from the crankshaft balancer.





7. Remove the EN 46106 - tool.