128. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools

* EN 41998-B - Crankshaft Balancer Installer

* EN 45059 - Angle Meter

* EN 46106 - Engine Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools Special Tools.





1. The EN 46106 - toolmust be installed onto the flywheel.

2. Use the EN 41998-B - installer, nut, bearing and washer to install the crankshaft balancer.





Note:
Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

3. Apply lubricant to the inside of the crankshaft balancer hub bore.





4. Place the crankshaft balancer in position on the crankshaft.

5. Thread the EN 41998-B - installerin the crankshaft. Ensure you engage at least 10 threads of the EN 41998-B - installerbefore pressing the crankshaft balancer in place.

6. Push the crankshaft balancer into position by tightening the nut on the J 41998-B - installeruntil the large washer bottoms out on the crankshaft end.

7. Remove the EN 41998-B - installer.





8. Install the NEW crankshaft balancer bolt.

Caution:
Refer to Fastener Caution Fastener Caution.

9. Tighten the crankshaft balancer bolt.

1. Tighten the crankshaft balancer bolt to 100 Nm (74 lb ft).

2. Tighten the crankshaft balancer bolt an additional 150 degreesusing the EN 45059 - meter.





10. Remove the EN 46106 - tool.