Shift Control Lever Replacement

Shift Control Lever Replacement

Removal Procedure





2. Unlock shift lever and selector lever cable adjust locks (2).

3. Clip shift lever and selector lever cable (3) out of transmission control lever housing (1).





4. Remove the four transmission control lever fasteners (1).

5. Remove transmission control lever (2).

Installation Procedure





1. Install NEW transmission control lever (2).

Caution:
Refer to Fastener Caution Fastener Caution in the Preface section.

2. Install the four transmission control lever fasteners (1) and tighten to 8 Nm (71 lb in).





Note:
Do not lock yet.

3. Slide shift lever and selector lever cable into shift lever and selector lever cable adjust locks (2).

4. Clip shift lever and selector lever cable (3) into transmission control lever housing (1).

5. Adjust shift lever and selector lever cable. Refer to Manual Transmission Shift Lever Cable Adjustment Manual Transmission Shift Lever Cable Adjustment.