Security Indicator Malfunction

Security Indicator Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information






Circuit/System Description

The security indicator is an LED controlled by the body control module (BCM) based on commands from the content theft deterrent system. The security indicator is located in the dash as part of the ambient light sensor and is supplied ground at all times. When the content theft deterrent system requests the indicator be commanded ON, the BCM applies voltage to the security indicator control circuit, illuminating the LED.

Reference Information

Schematic Reference

Theft Deterrent System Schematics Theft Deterrent System Schematics

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Theft Systems Description and Operation Theft Systems

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Arm the content theft deterrent system. The security indicator should illuminate and/or flash during the arming sequence.

Circuit/System Testing

1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the B10 ambient light sensor. It may take up to 2 minutes for all vehicle systems to power down.

2. Test for less than 30 ohms between the ground circuit terminal 6 and ground.

• If 30 ohms or greater

1. Ignition OFF.

2. Test for less than 2 ohms in the ground circuit end to end.

• If 2 ohms or greater, repair the open/high resistance in the circuit.

• If less than 2 ohms, repair the open/high resistance in the ground connection.

• If less than 30 ohms

3. Ignition ON, connect a test lamp between the control circuit terminal 1 and the ground circuit terminal 6.

4. Verify the test lamp turns ON and OFF when commanding the security indicator ON and OFF with a scan tool.

• If the test lamp is always OFF

1. Ignition OFF, disconnect the harness connector at the K9 body control module.

2. Test for infinite resistance between the control circuit and ground.

• If less than infinite resistance, repair the short to ground on the circuit.

• If infinite resistance

3. Test for less than 2 ohms in the control circuit end to end.

• If 2 ohms or greater, repair the open/high resistance in the circuit.

• If less than 2 ohms, replace the K9 body control module.

• If the test lamp is always ON

1. Ignition OFF, disconnect the harness connector at the K9 body control module, ignition ON.

2. Test for less than 1 V between the control circuit and ground.

• If 1 V or greater, repair the short to voltage on the circuit.

• If less than 1 V, replace the K9 body control module.

• If the test lamp turns ON and OFF

5. Test or replace the B10 ambient light sensor.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

* Sun Load Temperature Sensor Replacement Service and Repair

* Control Module References Control Module References for BCM replacement, programming and setup