9. Holding Fixture Installation

Holding Fixture Installation

Special Tools

* DT-552 - Installer

* DT-113-2-A - Holding Fixture Base

For equivalent regional tools, refer to Special Tools Tools and Equipment.





1. Install the transmission case (1) to the DT-552 - installer (4) and fix with two bolts (5).

Note:
Shift the transmission into reverse gear.

Note:
Ensure the DT-113-2-A - holding fixture base is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping.

2. Install the DT-552 - installer assembled with the transmission case to DT-113-2-A - holding fixture base (3) and lock with the lock pin (2).